D-Link DES-3326S Reference Manual - Page 221
create route redistribute dst ospf
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual create route redistribute dst ospf Purpose Used to add route redistribution settings for the exchange of RIP routes to OSPF routes on the switch. Syntax create route redistribute dst ospf src [static/rip/local] {mettype [1/2]/metric } Description This command will redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that are running OSPF or RIP. Routing information entered into the Static Routing Table on the local DES-3326SR switch is also redistributed. Parameters src [static/rip/local] − Allows for the selection of the protocol for the source device. dst − Allows for the selection of the protocol for the destination device. mettype [1/2] − Allows for the selection of one of two methods of calculating the metric value. Type-1 calculates (for RIP to OSPF) by adding the destination's interface cost to the metric entered in the Metric field. Type2 uses the metric entered in the Metric field without change. this field applies only when the destination field is OSPF. − Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the RIP routing protocol. Route Redistribution Commands 221