D-Link DES-3326S Reference Manual - Page 190
config link_aggregation
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config link_aggregation Purpose Used to configure a previously created link aggregation group. Syntax config link_aggregation group_id {master_port /ports / {state [enabled/disabled]} Description This command allows you to configure a link aggregation group that was created with the create link_aggregation command above. Parameters − Specifies the group id. The switch allows up to 6 link aggregation groups to be configured. The group number identifies each of the groups. − Master port ID. Specifies which port (by port number) of the link aggregation group will be the master port. All of the ports in a link aggregation group will share the port configuration with the master port. − specifies a range of ports to be configured. Ports are specified by entering the lowest port number in a group, and then the highest port number in a group, separated by a dash. So, a port group including the switch ports 1, 2, and 3 would be entered as 1-3. Ports that are not contained within a group are specified by entering their port number, separated by a comma. So, the port group 1-3 and port 26 would be entered as 1-3, 26. Additional ports can be individually entered by their 190 Link Aggregation Commands