D-Link DES-3326S Reference Manual - Page 47
config ports
UPC - 790069242755
View all D-Link DES-3326S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config ports Purpose Used to configure the switch's Ethernet port settings. Syntax config ports [] { spe e d[aut o /1 0 _half /1 0 _f ull/1 0 0 _half /1 0 0 _hal f/1000_full] learning [enabled/disabled] state [enabled/disabled]} Description This command allows for the configuration of the switch's Ethernet ports. Only the ports listed in the will be affected. Parameters all − Displays all ports on the switch. − Specifies a range of ports to be configured. The port list is specified by listing the beginning port number and the highest port number of the range. The beginning and end of the port list range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 3-4 specifies all of the ports between port 3 and port 4 − in numerical order. auto − Enables auto-negotiation for the specified range of ports. [10/100/1000] − Configures the speed in Mbps for the specified range of ports. Gigabit ports are statically set to 1000 and cannot be set to slower speeds. [half/full] − Configures the specified range of ports as either full- or half-duplex. learning [enabled/disabled] − Enables or disables Switch Port Commands 47