D-Link DES-3326S Reference Manual - Page 274

DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual config rip rx_mode Purpose Used to configure RIP on the switch. Syntax Description Parameters config rip [ipif /all] rx_mode [[di sable /v 1 _o nly ]/[v 2 _o nly /v 1 _and_v 2 ] authentication [enabled/disabled] ] This command is used to configure RIP on the switch. − The name of the IP interface. all − Specifies all IP interfaces on the switch. rx_mode − Determines how received RIP packets will be interpreted - as RIP version V1 only, V2 Only, or V1 and V2. This entry specifies which version of the RIP protocol will be used to receive RIP packets. The Disabled entry prevents the reception of RIP packets. disable − Prevents the reception of RIP packets. v1_only − Specifies that only RIP v1 packets will be accepted. v2_only − Specifies that only RIP v2 packets will be accepted. v1_and_v2 − Specifies that both RIP v1 and v2 packets will be accepted. authentication [enabled/disabled] − Enables or disables authentication for RIP on the switch. − Allows the specification of a case-sensitive password. state [enabled/disabled] − Allows RIP to be enabled and disabled on the switch. 274 RIP Commands