Dell Brocade 5100 Fabric OS v7.0.2 Release Notes v1.0 - Page 65
Defect ID, Technical Severity, Summary, Symptom, Workaround, Feature, Function, Probability, Found
View all Dell Brocade 5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Open Defects in Fabric OS v7.0.1 Defect ID: DEFECT000369286 Technical Severity: Medium Summary: Inconsistency in handling of unsupported port speed configuration after replacing an FC16xx blade with an FC8-xxE blade. Symptom: After replacing an FC16-xx blade with an FC8-xxE blade, ports previously configured to fixed 10G speed will be reset to auto speed negotiation while ports previously configured to fixed 16G will be persistently disabled. Workaround: Manually correct the configured port speed and reenable the port. Feature: 16G ASIC Driver Function: General Probability: High Found in Release: FOS7.0.1 Defect ID: DEFECT000371302 Technical Severity: Medium Summary: CEE/FCoE: protocol spanning tree config is not visible after spanning tree shut/no shut Symptom: If the customer changes the path cost to custom and does a shut/no shut the configuration will have flat set as standard but rest of the config will remain as custom. Workaround: Reconfigure "port-channel path-cost custom" and then configure "port-channel path-cost standard". Feature: CEE-LAYER2 Function: STP Probability: Medium Found in Release: FOS7.0.1 Defect ID: DEFECT000373589 Technical Severity: Medium Summary: The error message for a duplicate user assigned FAPWWN will show the slot/port as -1/-1 if the port is in a different logical switch. Symptom: If the user attempts to assign a WWN that has already been assigned to a port in a different logical switch, the following message is displayed: "Error: Virtual Port WWN is already mapped (FID , Switch port -1/-1)." This does not indicate the actual physical port with the duplicate WWN assignment. Workaround: Login to the FID indicated in the error message and issue "fapwwn --show all" to identify which port has the WWN already assigned. Feature: Fabric Provisioning Function: CLI Probability: High Found in Release: FOS7.0.1 Defect ID: DEFECT000374924 Technical Severity: Medium Summary: Port Admin Dialog: FC8-32E and FC8-48E blades will list speed combo values which are not supported on these platforms. Symptom: User will see speed combo values for FC8-32E and FC8-48E blades, but these settings are not valid for these blade types. Feature: WebMgmt Function: Ports Admin Probability: High Found in Release: FOS7.0.1 Fabric OS v7.0.2 Release Notes v1.0 Page 65 of 99