Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1029

First-hop interface is GigabitEthernet 1/3 Tracked by: VRRP GigabitEthernet 1/8 IPv6 VRID 1 The following example shows verifying the VRRP status. ON the MASTER ========== Dell#show vrrp TenGigabitEthernet 0/1, IPv4 VRID: 1, Version: 2, Net: 1.1.1.1 VRF: 0 default State: Master, Priority: 100, Master: 1.1.1.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 36, Gratuitous ARP sent: 1 Virtual MAC address: 00:00:5e:00:01:01 Virtual IP address: 1.1.1.100 Authentication: (none) Dell# ON the STANDBY Dell#show vrrp TenGigabitEthernet 0/1, IPv4 VRID: 1, Version: 2, Net: 1.1.1.2 VRF: 0 default State: Backup, Priority: 100, Master: 1.1.1.1 Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 65, Bad pkts rcvd: 0, Adv sent: 0, Gratuitous ARP sent: 0 Virtual MAC address: 00:00:5e:00:01:01 Virtual IP address: 1.1.1.100 Authentication: (none) Dell# Tracking states for 2 resource Ids: 2 - Up IPv6 route, 2040::/64, priority-cost 20, 00:02:11 3 - Up IPv6 route, 2050::/64, priority-cost 30, 00:02:11 The following example shows verifying the VRRP configuration on an interface. Dell#show running-config interface tengigabitethernet 1/8/1 interface TenGigabitEthernet 1/8/1 no ip address ipv6 address 2007::30/64 vrrp-ipv6-group 1 track 2 priority-cost 20 track 3 priority-cost 30 virtual-address 2007::1 virtual-address fe80::1 no shutdown Sample Configurations Before you set up VRRP, review the following sample configurations. VRRP for an IPv4 Configuration The following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. To Virtual Router Redundancy Protocol (VRRP) 1029