Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 70

Configuring FTP Server Parameters After you enable the FTP server on the system, you can configure different parameters. To specify the system logging settings, use the following commands. • Specify the directory for users using FTP to reach the system. CONFIGURATION mode ftp-server topdir dir The default is the internal flash directory. • Specify a user name for all FTP users and configure either a plain text or encrypted password. CONFIGURATION mode ftp-server username username password [encryption-type] password Configure the following optional and required parameters: - username: enter a text string. - encryption-type: enter 0 for plain text or 7 for encrypted text. - password: enter a text string. NOTE: You cannot use the change directory (cd) command until you have configured ftp-server topdir. To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode. Configuring FTP Client Parameters To configure FTP client parameters, use the following commands. • Specify an FTP interface source. CONFIGURATION mode ip ftp source-interface interface Enter the following keywords and slot/port or number information: - For a loopback interface, enter the keyword loopback then a number between 0 and 16383. - For a port channel interface, enter the keywords port-channel then a number from 1 to 255. - For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. - For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. - For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. • Configure a password. CONFIGURATION mode ip ftp password password • Enter a username to use on the FTP client. CONFIGURATION mode ip ftp username name To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode, as shown in the example for Enable FTP Server. Switch Management 70