Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 116

ip access-list standard access-list-name 2 Configure a drop or forward IP ACL filter. CONFIG-STD-NACL mode {deny | permit} {source [mask] | any | host ip-address} [count [byte]] [order] [fragments] When you use the log keyword, the CP logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. The following example shows a standard IP ACL in which the system assigns the sequence numbers. The filters were assigned sequence numbers based on the order in which they were configured (for example, the first filter was given the lowest sequence number). The show config command in IP ACCESS LIST mode displays the two filters with the sequence numbers 5 and 10. Examples of Viewing Filter Sequence Standard ACLs The following example shows viewing a filter sequence for a specified standard ACL. Dell(config-route-map)#ip access standard kigali Dell(config-std-nacl)#permit 10.1.0.0/16 Dell(config-std-nacl)#show config ! ip access-list standard kigali seq 5 permit 10.1.0.0/16 seq 10 deny tcp any any eq 111 Dell(config-std-nacl)# To view all configured IP ACLs, use the show ip accounting access-list command in EXEC Privilege mode. Dell#show ip accounting access example interface gig 4/12 Extended IP access list example seq 10 deny tcp any any eq 111 seq 15 deny udp any any eq 111 seq 20 deny udp any any eq 2049 seq 25 deny udp any any eq 31337 seq 30 deny tcp any any range 12345 12346 seq 35 permit udp host 10.21.126.225 10.4.5.0 /28 seq 40 permit udp host 10.21.126.226 10.4.5.0 /28 seq 45 permit udp 10.8.0.0 /16 10.50.188.118 /31 range 1812 1813 seq 50 permit tcp 10.8.0.0 /16 10.50.188.118 /31 eq 49 seq 55 permit udp 10.15.1.0 /24 10.50.188.118 /31 range 1812 1813 To delete a filter, enter the show config command in IP ACCESS LIST mode and locate the sequence number of the filter you want to delete. Then use the no seq sequence-number command in IP ACCESS LIST mode. Configure an Extended IP ACL Extended IP ACLs filter on source and destination IP addresses, IP host addresses, TCP addresses, TCP host addresses, UDP addresses, and UDP host addresses. Because traffic passes through the filter in the order of the filter's sequence, you can configure the extended IP ACL by first entering IP ACCESS LIST mode and then assigning a sequence number to the filter. Configuring Filters with a Sequence Number To configure filters with a sequence number, use the following commands. 1 Enter IP ACCESS LIST mode by creating an extended IP ACL. CONFIGURATION mode ip access-list extended access-list-name 2 Configure a drop or forward filter. CONFIG-EXT-NACL mode Access Control Lists (ACLs) 116