Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 397

Link to Peer: Up -- PEER RPM Status -- RPM State: Standby RPM SW Version: 1-0(0-4095) -- Control Plane Redundancy Configuration -- Primary RPM: rpm0 Auto Data Sync: Full Failover Type: Hot Failover Auto reboot RPM: Enabled Auto failover limit: 3 times in 60 minutes -- Control Plane Failover Record -- Failover Count: 0 Last failover timestamp: None Last failover Reason: None Last failover type: None -- Last Data Block Sync Record: -- linecard Config: succeeded Jun 26 2015 22:56:16 Start-up Config: succeeded Jun 26 2015 22:56:16 Runtime Event Log: succeeded Jun 26 2015 22:56:16 Running Config: succeeded Jun 26 2015 22:56:16 RPM Synchronization Data between the primary (management) and standby RPMs is synchronized immediately after bootup. After the two RPMs have performed an initial full synchronization (block sync), the system automatically updates only changed data (incremental sync). The data that is synchronized consists of configuration data, operational data, state and status, and statistics depending on the version of the Dell Networking OS. You can manually synchronize the primary and standby RPMs at any time by entering the redundancy synchronize full command. Forcing an RPM Failover To force an RPM failover, use the following command. Use this feature when you are replacing an RPM and when you are performing a warm upgrade. • To trigger an RPM failover. EXEC Privilege mode redundancy force-failover rpm NOTE: You can also force the port extender to failover from the RPM, using the redundancy force-failover pe pe-id command in EXEC Privilege mode. Example of the redundancy force-failover rpm Command Dell#redundancy force-failover rpm Dell#redundancy force-failover pe pe-id High Availability (HA) 397