Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 677

• lt = less than • range = inclusive range of ports (you must specify two ports for the port command parameter.) source ip-address or any or host ip-address (Optional) - Source's IP address or host from which they packets were sent. mask (Optional) - network mask /prefix format (/x). any (Optional) - Specifies that all traffic is subject to the filter. destination mask - IP address of the network or host to which the packets are sent. FORMAT: A.B.C.D/NN, or ANY or HOST IP address Below is an example: Dell(conf-redirect-list)#redirect 1.1.1.1 tcp an any ? ack Match on the ack bit eq Match only packets on a given port number fin Match on the fin bit gt Match only packets with a greater port number lt Match only packets with a lower port number neq Match only packets not on a given port number psh Match on the psh bit range Match only packets in the range of port numbers rst Match on the rst bit syn Match on the syn bit urg Match on the urg bit cr Dell(conf-redirect-list)#redirect 1.1.1.1 udp any any ? eq Match only packets on a given port number gt Match only packets with a greater port number lt Match only packets with a lower port number neq Match only packets not on a given port number range Match only packets in the range of port numbers Delete a rule with the no redirect command. The redirect rule supports Non-contiguous bitmasks for PBR in the Destination router IP address The below step shows a step-by-step example of how to create a rule for a redirect list by configuring: • IP address of the next-hop router in the forwarding route • IP protocol number • Source address with mask information • Destination address with mask information Creating a Rule Example: Dell(conf-redirect-list)#redirect ? A.B.C.D Forwarding router's address Dell(conf-redirect-list)#redirect 3.3.3.3 ? Policy-based Routing (PBR) 677