Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 427

O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2, E1 - OSPF external type 1, E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default, > - non-active route, + - summary route Gateway of last resort is not set Destination ----------C 6.1.1.0/24 C 10.1.1.0/24 *S 0.0.0.0/0 00:01:12 Dell# Gateway ------Direct, Fo 2/12 Direct, Vl 10 via 6.1.1.1, Fo 2/12 Port Extender Interfaces Dist/Metric Last Change 0/0 00:01:12 0/0 01:09:08 0/0 You can use a C9010 switch with an attached C1048P port extender (PE) to expand the port density of the chassis. In this configuration, the C9010 operates as a controlling bridge for the C1048P. The C1048P functions as a remote line card that is physically connected to, and automatically provisioned by, a C9010 over 10GE links according to the IEEE 802.1BR standard. After the initial C1048P software provisioning is performed, you can configure L2 features on the C1048P by entering CLI commands on a C9010. C1048P interfaces are identified in the command syntax: interface peGigE pe-id/pe-stack-unit-id/port-number • pe-id is a port-extender group ID number from 0 to 255. • pe-stack-unit-id is a PE stack-unit number from 0 to 7. • port-number is a port number from 1 to 48 (see Port Numbering). Dell(conf)#interface peGigE ? PE-ID/UNIT/PORT PE Gigabit Ethernet interface number Dell(conf)#interface peGigE 2/0/1 For more information on how to configure and use port extenders with C9000 Series switches, see Port Extenders (PEs) and Port Extender (PE) Stacking. For information about how to install a PE and set up a PE stack, see the C1048P Getting Started Guide and C1048P Installation Guide. VLAN Interfaces VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs. The supported VLAN range is 1 - 4094. For more information about VLANs and Layer 2, refer to Layer 2 and Virtual LANs (VLANs). NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based internets: MIB-II (RFC 1213). NOTE: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN. The system supports Inter-VLAN routing (Layer 3 routing in VLANs). You can add IP addresses to VLANs and use them in routing protocols in the same manner that physical interfaces are used. For more information about configuring different routing protocols, refer to the chapters on the specific protocol. A consideration for including VLANs in routing protocols is that you must configure the no shutdown command. (For routing traffic to flow, you must enable the VLAN.) NOTE: You cannot assign an IP address to the default VLAN, which is VLAN 1 (by default). To assign another VLAN ID to the default VLAN, use the default vlan-id vlan-id command. To assign an IP address to an interface, use the following command. Interfaces 427