Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 706

41 Port Extender (PE) Stacking You can stack up to eight C1048P port extenders using the mini-SAS stack ports on the back panel. The C1048P supports stacking only with other C1048P port extenders. Stacking is not supported on C9010 switches. To set up a PE stack, follow the installation procedure in the Dell Networking C1048P Getting Started Guide or Dell Networking C1048P Installation Guide. Each C1048P has 48 user ports, two uplink ports, and two stack-ports. When you connect multiple C1048Ps together through the stack ports, they operate as a single unit with up to 384 front panel ports. The port extender stack operates and is managed as a single entity through a C9000 Series switch. Provision individual C1048Ps by entering commands in PE Configuration mode from a C9010 console. The PE configuration is applied to a C1048P following its discovery and successful authentication by the parent C9010. If the master unit in a PE stack fails, stack ownership transfers to the standby unit. If a standby unit fails, the stack master does not experience interrupted operation. A new standby unit is elected from the other member units. Topics: • Stack Management Roles • Stack Master Election • Important Points to Remember • PE Stack Configuration • Locating the Port Extender • Troubleshooting a PE Stack Stack Management Roles After you assemble and cable a stack of port extenders and power the stack units on, the units receive the provisioned configuration from the parent C9010. A stack master unit is elected based on the highest MAC address. The master may occupy any position in the stack. The Master LED on the front panel is illuminated on the master unit. The stack unit with the second highest MAC address is elected as the standby or backup management unit. The standby assumes the master role if the master unit in the stack fails. The PE with the next highest priority or MAC address becomes standby. All remaining stack units function as stack members. Although the master and standby units are automatically selected by MAC address, you can configure PE priorities to specify which units are assigned the master and standby roles. Stack Master Election When a PE stack reloads and all stack units come up, all units participate in the stack master election. The master and standby units are chosen based on the priority or MAC address. The stack takes the MAC address of the master unit. • Unit priority - The range is from 1 to 14. The unit with the highest priority is elected the master management unit; the unit with the second highest priority is elected the standby unit. The default is 0. To remove a priority and set the priority to 0, enter the no stack-unit unit-number priority command in PE CONFIGURATION mode. • MAC address (if there is a priority tie) - By default, the unit with the highest MAC value becomes the master unit if no priorities are configured. A change in the stack master occurs when: Port Extender (PE) Stacking 706