Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 968

Task Create VRF Assign the VRF to an interface Assign an IP address to the interface Configure the VRRP group and virtual IP address View VRRP command output for the VRF vrf1 Command Syntax ip vrf vrf1 ip vrf forwarding vrf1 ip address 10.1.1.1 /24 no shutdown Command Mode CONFIGURATION VRF CONFIGURATION Configuring Management VRF You can assign a management interface to a management VRF. Task Command Syntax Create a management VRF. ip vrf management Assign a management port to a management VRF. interface management Command Mode CONFIGURATION VRF MODE Configuring a Static Route To configure a static route, perform the following steps: Task Configure a static route that points to a management interface. Command Syntax Command Mode management route ip-address mask managementethernet ormanagement route ipv6-address prefix-length managementethernet CONFIGURATION NOTE: You can also have the management route to point to a front-end port in case of the management VRF. For example: management route 2::/64 te 0/0. To configure a static entry in the IPv6 neighbor discovery, perform the following steps: Task Configure a static neighbor. Command Syntax Route Leaking VRFs Command Mode CONFIGURATION Static routes can be used to redistribute routes between non-default to default/non-default VRF and vice-versa. NOTE: Route leaking VRFs are supported only for IPv4 routes. You can configure route leaking between two VRFs using the following command: ip route vrf x.x.x.x s.s.s.s nh.nh.nh.nh vrf default. Virtual Routing and Forwarding (VRF) 968