Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 593

Dell(conf)#do show spanning-tree mst config MST region name: my-mstp-region Revision: 0 MSTI VID 1 100 2 200-300 Modifying Global Parameters The root bridge sets the values for forward-delay, hello-time, max-age, and max-hops and overwrites the values set on other MSTP bridges. • Forward-delay - the amount of time an interface waits in the Listening state and the Learning state before it transitions to the Forwarding state. • Hello-time - the time interval in which the bridge sends MSTP bridge protocol data units (BPDUs). • Max-age - the length of time the bridge maintains configuration information before it refreshes that information by recomputing the MST topology. • Max-hops - the maximum number of hops a BPDU can travel before a receiving switch discards it. NOTE: Dell Networking recommends that only experienced network administrators change MSTP parameters. Poorly planned modification of MSTP parameters can negatively affect network performance. To change the MSTP parameters, use the following commands on the root bridge. 1 Change the forward-delay parameter. PROTOCOL MSTP mode forward-delay seconds The range is from 4 to 30. The default is 15 seconds. 2 Change the hello-time parameter. PROTOCOL MSTP mode hello-time seconds NOTE: With large configurations (especially those configurations with more ports) Dell Networking recommends increasing the hello-time. The range is from 1 to 10. The default is 2 seconds. 3 Change the max-age parameter. PROTOCOL MSTP mode max-age seconds The range is from 6 to 40. The default is 20 seconds. 4 Change the max-hops parameter. PROTOCOL MSTP mode max-hops number The range is from 1 to 40. The default is 20. Multiple Spanning Tree Protocol (MSTP) 593