Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 419

Resetting an Interface to its Factory Default State You can reset any configurations applied on an interface to its factory default state. To reset the configuration, perform the following steps: 1 View the configurations applied on an interface. INTERFACE mode show config Dell(conf)# interface range tengigabitethernet 1/1 - 2 Dell(conf-if-range-te-1/1-2)# show config ! interface TenGigabitEthernet 1/1 switchport no shutdown ! interface TenGigabitEthernet 1/2 no ip address Interfaces 893 switchport no shutdown Dell(conf-if-range-te-1/1-2)# 2 Reset an interface to its factory default state. CONFIGURATION mode default interface interface-type slot/port[] Dell(conf)#default interface tengigabitethernet 1/5 3 Verify the configuration. INTERFACE mode show config Dell(conf-if-te-1/5)#show config ! interface TenGigabitEthernet 1/5 no ip address shutdown All the applied configurations are removed and the interface is set to the factory default state. Enabling a Physical Interface After determining the type of physical interfaces available, to enable and configure the interfaces, enter INTERFACE mode by using the interface interface {slot/port | pe-id/stack-unit/port} command. 1 Enter the keyword interface then the type of interface and slot/port information. CONFIGURATION mode interface interface • For the Management interface, enter the keyword ManagementEthernet then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then the pe-id/stack-unit /port-id information. 2 Enable the interface. INTERFACE mode Interfaces 419