Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 636

When disabled, the parameter is set at 0. NOTE: A higher convergence level can result in occasional loss of OSPF adjacency. Generally, convergence level 1 meets most convergence requirements. Only select higher convergence levels following consultation with Dell Technical Support. Examples of Enabling Fast-Convergence In the following examples, Convergence Level shows the fast-converge parameter setting and Min LSA origination shows the LSA parameters (shown in bold). The following example shows the fast-converge command. Dell(conf-router_ospf-1)#fast-converge 2 Dell(conf-router_ospf-1)#ex Dell(conf)#ex Dell#show ip ospf 1 Routing Process ospf 1 with ID 192.168.67.2 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 2 Min LSA origination 0 secs, Min LSA arrival 0 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 Dell# To disable fast-convergence, use the no fast-converge command. Dell#(conf-router_ospf-1)#no fast-converge Dell#(conf-router_ospf-1)#ex Dell#(conf)#ex Dell##show ip ospf 1 Routing Process ospf 1 with ID 192.168.67.2 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 0 Min LSA origination 5 secs, Min LSA arrival 1 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 Dell# Changing OSPFv2 Parameters on Interfaces You can modify the OSPF configuration on switch interfaces. Some interface parameter values must be consistent across all interfaces to avoid routing errors. For example, set the same time interval for the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors. To change OSPFv2 parameters on the interfaces, use any or all of the following commands. • Change the cost associated with OSPF traffic on the interface. CONFIG-INTERFACE mode ip ospf cost - cost: The range is from 1 to 65535 (the default depends on the interface speed). • Change the time interval the router waits before declaring a neighbor dead. CONFIG-INTERFACE mode ip ospf dead-interval seconds - seconds: the range is from 1 to 65535 (the default is 40 seconds). The dead interval must be four times the hello interval. The dead interval must be the same on all routers in the OSPF network. • Change the time interval between hello-packet transmission. Open Shortest Path First (OSPFv2 and OSPFv3) 636