Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1038

www.dell.com | support.dell.com Example Figure 39-4. Command Example: router ospf Force10(conf)#router ospf 2 Force10(conf-router_ospf)# Usage You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure Information OSPF. Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the system. show config c e s Display the non-default values in the current OSPF configuration. Syntax show config Command Modes ROUTER OSPF Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 39-5. Command Example: show config Force10(conf-router_ospf)#show config ! router ospf 3 passive-interface FastEthernet 0/1 Force10(conf-router_ospf)# show ip ospf c e s Display information on the OSPF process configured on the switch. Syntax show ip ospf process-id [vrf vrf name] Parameters process-id vrf name Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. E-Series Only: Show only the OSPF information tied to the VRF process. Command Modes EXEC EXEC Privilege Command History Version 7.9.1.0 Version 7.9.1.0 Version 7.8.1.0 Version 7.8.1.0 Introduced VRF Introduced VRF Introduced support of Multi-Process OSPF. Introduced process-id option, in support of Multi-Process OSPF. 1038 | Open Shortest Path First (OSPFv2 and OSPFv3)