Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 905

multiplier c e s Set the number of consecutive misses before LLDP declares the interface dead. Syntax multiplier integer To return to the default, use the no multiplier integer command. Parameters integer Enter the number of consecutive misses before the LLDP declares the interface dead. Range: 2 - 10 Defaults 4 x hello Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series protocol lldp (Configuration) c e s Enable LLDP globally on the switch. Syntax protocol lldp To disable LLDP globally on the chassis, use the no protocol lldp command. Defaults Disabled Command Modes CONFIGURATION (conf-lldp) Command History Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series protocol lldp (Interface) c e s Enter the LLDP protocol in the INTERFACE mode. Syntax [no] protocol lldp To return to the global LLDP configuration mode, use the no protocol lldp command from the Interface mode. Defaults LLDP is not enabled on the interface. Command Modes INTERFACE (conf-if-interface-lldp) Command History Version 7.7.1.0 Introduced on S-Series Link Layer Detection Protocol (LLDP) | 905