Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1061
show ip ospf topology
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1061 highlights
Example The show ip ospf process-id statistics command displays the error packet count received on each interface as: • The hello-timer remaining value for each interface • The wait-timer remaining value for each interface • The grace-timer remaining value for each interface • The packet count received and transmitted for each neighbor • Dead timer remaining value for each neighbor • Transmit timer remaining value for each neighbor • The LSU Q length and its highest mark for each neighbor • The LSR Q length and its highest mark for each neighbor Figure 39-20. Command Example: show ip ospf process-id statistics Force10#show ip ospf 100 statistics Interface GigabitEthernet 0/8 Hello-Timer 9, Wait-Timer 0, Grace-Timer 0 Error packets (Only for RX) Intf-Down Wrong-Len Auth-Error Version SeqNo-Err 0 Non-Dr 0 Invld-Nbr 0 MD5-Error 0 AreaMisMatch 0 Unkown-Pkt 0 Self-Org 0 0 Nbr-State 0 0 Cksum-Err 0 0 Conf-Issue 0 0 Neighbor ID 9.1.1.2 Hello DDiscr LSReq LSUpd LSAck RX 59 3 1 1 1 TX 62 2 1 0 0 Dead-Timer 37, Transmit-Timer 0 LSU-Q-Len 0, LSU-Q-Wmark 0 LSR-Q-Len 0, LSR-Q-Wmark 1 Related Commands clear ip ospf statistics Clear the packet statistics in all interfaces and neighbors show ip ospf topology c e s Display routers in directly connected areas. Syntax show ip ospf process-id topology Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults No default values or behavior Command Modes EXEC EXEC Privilege Command History Version 7.8.1.0 Introduced support of Multi-Process OSPF. Open Shortest Path First (OSPFv2 and OSPFv3) | 1061