Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 524

www.dell.com | support.dell.com test-list c e Enter the name of a configured test list to be associated with the selected policy. Syntax test-list word Parameters word Enter the keyword test-list followed by the name of a configured test list. Defaults No default behavior or values Command Mode config-callhome-policy-name Command History Usage Information Version 7.7.1.0 Introduced on C-Series and E-Series Executing the policy-test-list command puts you in the config-callhome-testlist mode, where you use this command to invoke one of three possible test groups. FTOS monitors the system for any event in the selected test group. If such an event occurs, FTOS invokes the action you defined using the default-action command and then associate in this policy with the action-list command. Table 20-1. FTSA Test Sets Hardware test set Software test set SFM status transition from active to other SWP Timeout state Line card transition from active to other IPC Timeout state Port-pipe error or transition to down IRC Timeout RPM status transition from active to other CPU usage more than 85% state PEM transition from up to other state Memory usage more than 85% AC power supply transition from up to other state Fan tray down or individual fan down Overtemp of any item listed in show environment Over/under-voltage of any item listed in show environment Exception test set CPU usage more than 85% System crash Task crash Dump, reload due to error, RPM failover due to error Related Commands action-list case-number dampen policy policy-test-list Specify a policy action list for the associated policy and enter the conf-call-home-actionlist-name mode. Specify a case number for the associated policy. Set a delay before sampling for a test condition again after it has been matched. Create a policy name and enter config-callhome-policy-name mode. Name a policy test list and enter the config-callhome-testlist-name mode. 524 | Force10 Service Agent