Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1184

www.dell.com | support.dell.com If you receive the error message: %Error: Specified VLANs overlap with existing config. after configuring VLANs in the rate police command, check to see if the same VLANs are used in rate limit command on other interfaces. To clear the problem, remove the rate limit configuration(s), and re-configure the rate police command. After the rate police command is configured, return to the other interfaces and re-apply the rate limit configuration. rate police c e s Police the incoming traffic rate on the selected interface. Syntax Parameters rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] [vlan vlan-id] kbps committed-rate burst-KB peak peak-rate vlan vlan-id Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On C-Series and S-Series make the following value a multiple of 64. On the E-Series, Dell Force10 recommends using a value greater than or equal to 512 as lower values does not yield accurate results. The default granularity is Megabits per second (Mbps). Range: 0 to 10000000 Enter a number as the bandwidth in Mbps. Range: 0 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 16 to 200000 Default: 50 (OPTIONAL) Enter the keyword peak followed by a number to specify the peak rate in Mbps. Range: 0 to 10000 (OPTIONAL) Enter the keyword vlan followed by a VLAN ID to police traffic to those specific VLANs. Range: 1 to 4094 Defaults Granularity for committed-rate and peak-rate is Mbps unless the kbps option is used. Command Mode INTERFACE Command History Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Added kbps option on C-Series, E-Series, and Series. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information Note: Per Port rate limit and rate police is supported for Layer 2 tagged and untagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on only tagged ports with Layer 2 switched traffic. 1184 | Quality of Service (QoS)