Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 620
minimum-links, interface port-channel Command Example
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 620 highlights
www.dell.com | support.dell.com Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Figure 24-43. interface port-channel Command Example Force10(conf)#int port-channel 2 Force10(conf-if-po-2)# Usage Information Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the switchport command) or Layer 3 mode (by configuring an IP address). You can add a Port Channel in Layer 2 mode to a VLAN. The shutdown, description, and name commands are the only commands that you can configure on an interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the interface can only have the shutdown, description, and name commands configured. The Port Channel's configuration is applied to the interfaces within the Port Channel. A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on the first interface configured in the Port Channel and enabled, FTOS determines if the Port Channel uses 100 Mb/s or 1000 Mb/s as the common speed. Refer to channel-member for more information. If the line card is in a Jumbo mode chassis, then the mtu and ip mtu commands can also be configured. The Link MTU and IP MTU values configured on the channel members must be greater than the Link MTU and IP MTU values configured on the Port Channel interface. Note: In a Jumbo-enabled system, all members of a Port Channel must be configured with the same link MTU values and the same IP MTU values. Related Commands channel-member interface interface loopback interface null interface vlan shutdown Add a physical interface to the LAG. Configure a physical interface. Configure a Loopback interface. Configure a null interface. Configure a VLAN. Disable/Enable the port channel. minimum-links c e s Configure the minimum number of links in a LAG (Port Channel) that must be in "oper up" status for the LAG to be also in "oper up" status. Syntax minimum-links number 620 | Interfaces