Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 572
interface, interface loopback, interface Command Example, loopback, GigabitEthernet
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 572 highlights
www.dell.com | support.dell.com interface c e s Configure a physical interface on the switch. Syntax interface interface Parameters interface Enter one of the following keywords and slot/port or number information: • For 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For SONET interfaces, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Example Figure 24-5. interface Command Example Force10(conf)#interface gig 0/0 Force10(conf-if-gi-0/0)#exit# Usage Information You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface's configuration does not contain an IP address and enter the switchport command. Related Commands interface loopback interface null interface port-channel interface sonet interface vlan show interfaces Configure a Loopback interface. Configure a Null interface. Configure a port channel. Configure a SONET interface. Configure a VLAN. Display interface configuration. interface loopback c e s Configure a Loopback interface. Syntax interface loopback number To remove a loopback interface, use the no interface loopback number command. 572 | Interfaces