Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 577
interface range macro define, Multiple Range Bulk Configuration with SONET, VLAN, and port channel
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 577 highlights
The following figure shows how to use commas to add SONET, VLAN, and port-channel interfaces to the range. Example Figure 24-14. Multiple Range Bulk Configuration with SONET, VLAN, and port channel Force10(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2, Vlan 2 - 100 , Port 1 - 25 Force10(config-if-range)# no shutdown Force10(config-if-range)# Related Commands interface port-channel interface vlan show config (from INTERFACE RANGE mode) show range interface range macro (define) Configure a port channel group. Configure a VLAN interface. Show the bulk configuration interfaces. Show the bulk configuration ranges. Define a macro for an interface-range. interface range macro (define) c e s Defines a macro for an interface range and then saves the macro in the running configuration. Syntax define interface range macro name interface , interface , ... Parameters name interface , interface ,... Enter up to 16 characters for the macro name. Enter the interface keyword (see below) and one of the interfaces slot/ port, port-channel or VLAN numbers. Select the range of interfaces for bulk configuration. You can enter up to six comma separated ranges-spaces are not required between the commas. Comma-separated ranges can include VLANs, port-channels and physical interfaces. Slot/Port information must contain a space before and after the dash. For example, interface range gigabitethernet 0/1 - 5 is valid; interface range gigabitethernet 0/1-5 is not valid. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults This command has no default behavior or value Command Modes CONFIGURATION Interfaces | 577