Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1409

stack-unit provision s Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional command that is executed on the management unit. Syntax stack-unit 0-7 provision {S25N|S25P|S25V|S50N|S50V} Parameters 0-7 S25N|S25P|S25V|| S50N|S50V Enter a stack member identifier, from 0 to 7, of the switch that you want to add to the stack. Enter the S-Series model identifier of the switch to be added as a stack member. This identifier is also referred to as the provision type. Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identifier. Command Modes CONFIGURATION Command History Related Commands Version 7.7.1.0 Introduced on S-Series reload show system (S-Series) Reboot FTOS. Display the current status of all stack members or a specific member. stack-unit renumber s Change the stack member ID of any stack member or a stand-alone S-Series. Syntax stack-unit 0-7 renumber 0-7 Parameters 0-7 The first instance of this value is the stack member unit identifier, from 0 to 7, of the switch that you want add to the stack. The second instance of this value is the desired new unit identifier number. Defaults none Command Modes EXEC Privilege Command History Version 7.7.1.0 Introduced on S-Series Usage Information You can renumber any switch, including the management unit or a stand-alone unit. You cannot renumber a unit to a number of an active member in the stack. When executing this command on the master, the stack reloads. When the members are renumbered, only that specific unit will reset and come up with the new unit number. S-Series Stacking Commands | 1409