Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1473

ip vrf forwarding e Assign this interface to the VLAN specified. Syntax ip vrf forwarding vrf-name Parameters vrf-name Enter the name of the VRF instance to which this interface will belong. If no name is entered, default-vrf is assigned. Command Modes INTERFACE Command History Usage Information Version 8.2.1.0 Introduced on the E-Series There must be no prior Layer 3 configuration on the interface when configuring VRF. VRF must be enabled prior to implementing this command. Starting in release 8.4.1.0, you can configure an IP subnet or address on a physical or VLAN interface that overlaps the same IP subnet or address configured on another interface only if the interfaces are assigned to different VRFs. If two interfaces are assigned to the same VRF, you cannot configure overlapping IP subnets or the same IP address on them. Example Force10(conf-if-gi-1/1)#int gi 1/10 Force10(conf-if-gi-1/10)#show config ! interface GigabitEthernet 1/10 no ip address No configuration on this interface shutdown Force10(conf-if-gi-1/10)# Force10(conf-if-gi-1/10)#ip vrf ? Force10(conf-if-gi-1/10)#ip vrf forwarding East Force10(conf-if-gi-1/10)#show config ! interface GigabitEthernet 1/10 ip vrf forwarding East no ip address shutdown Force10(conf-if-gi-1/10)# Related Commands ip vrf ip vrf-vlan-block start-vlan-id Set the name of the VRF instance the VRF, or specify the default-vrf. Configure the total number of VLANs that can be configured per VRF. Set the starting VLAN ID for a VRF instance. Virtual Routing and Forwarding (VRF) | 1473