Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 108

www.dell.com | support.dell.com To configure a filter without a specified sequence number, use these commands in the following sequence, starting in the CONFIGURATION mode: Step Command Syntax Command Mode 1 ip access-list standard access-list-name CONFIGURATION 2 {deny | permit} {source [mask] | any CONFIG-STD-NACL | host ip-address} [count [byte] | log ] [order] [monitor] [fragments] Purpose Create a standard IP ACL and assign it a unique name. Configure a drop or forward IP ACL filter. • log and monitor options are supported on E-Series only. When you use the log keyword, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. Figure 7-5 illustrates a standard IP ACL in which the sequence numbers were assigned by the FTOS. The filters were assigned sequence numbers based on the order in which they were configured (for example, the first filter was given the lowest sequence number). The show config command in the IP ACCESS LIST mode displays the two filters with the sequence numbers 5 and 10. Figure 7-5. Standard IP ACL Force10(config-route-map)#ip access standard kigali Force10(config-std-nacl)#permit 10.1.0.0/16 Force10(config-std-nacl)#show config ! ip access-list standard kigali seq 5 permit 10.1.0.0/16 Force10(config-std-nacl)# To view all configured IP ACLs, use the show ip accounting access-list command (Figure 229) in the EXEC Privilege mode. Figure 7-6. Command Example: show ip accounting access-list Force10#show ip accounting access example interface gig 4/12 Extended IP access list example seq 10 deny tcp any any eq 111 seq 15 deny udp any any eq 111 seq 20 deny udp any any eq 2049 seq 25 deny udp any any eq 31337 seq 30 deny tcp any any range 12345 12346 seq 35 permit udp host 10.21.126.225 10.4.5.0 /28 seq 40 permit udp host 10.21.126.226 10.4.5.0 /28 seq 45 permit udp 10.8.0.0 /16 10.50.188.118 /31 range 1812 1813 seq 50 permit tcp 10.8.0.0 /16 10.50.188.118 /31 eq 49 seq 55 permit udp 10.15.1.0 /24 10.50.188.118 /31 range 1812 1813 To delete a filter, enter the show config command in the IP ACCESS LIST mode and locate the sequence number of the filter you want to delete. Then use the no seq sequence-number command in the IP ACCESS LIST mode. 108 | Access Control Lists (ACL), Prefix Lists, and Route-maps