Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 514

www.dell.com | support.dell.com View the amount of power that a port is consuming using the show power inline command from EXEC privilege mode. Figure 27-2. PoE Allocation Displayed with show power inline Command (example from C-Series) Force10#show power inline Interface Admin Gi 0/40 auto Gi 0/41 auto Gi 0/40 auto Oper ---on on on Inline Power Allocated (Watts 7.00 0.00 7.00 Inline Power Class Consumed (Watts) 3.20 2 0.00 NO_DEVICE 3.20 2 User Priority ---------Low High Low Table 27-3 describes the fields that the show power inline command displays: Table 27-3. show power inline Field Description Field Interface Admin Oper Inline Power Allocated Inline Power Consumed Class Port Number Displays all PoE-enabled ports. Displays the administrative mode of the interface: • auto indicates that power is supplied according to the requirements of the powered device. • static indicates that the maximum configured amount of power is supplied to the powered device. Displays the system PoE operational status for the port. This signifies the readiness of a port to supply power. It is "on" when the system is able to supply sufficient power to port. It will be "off" when there is no power available for port. This column does not reflect the PDs operational status. Displays the amount of power that can be allocated to a port if sufficient power is available. When sufficient power is not available for particular port based on the priority logic, then FTOS sets the PoE Oper status for the port is to "off" and inline power is not supplied to that port. If you insert an additional power supply, or when the priority of the port is increased, then the system supplies the allocated power to the port. Displays the amount of power that a powered device is consuming. Displays the type of powered device: Class 0, Class 1, Class 2, Class 3, or Class 4. Displays NO_DEVICE if no PD is connected. 514 | Power over Ethernet