Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 722

www.dell.com | support.dell.com Figure 40-7. Accessing Non-Master Units on a Stack via the Console Port CONSOLE ACCESS ON THE STANDBY Stack(standby)>? disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC show Show running system information ssh-peer-stack-unit Open a SSH connection to the peer Stack-unit telnet-peer-stack-unit Open a telnet connection to the peer Stack-unit terminal Set terminal line parameters Stack(standby)>show ? calendar Display the hardware calendar clock Display the system clock command-history CLI command history redundancy Current Stack unit HA status version Software version CONSOLE ACCESS ON A MEMBER Stack(stack-member-0)#? reset-self Reset this unit alone show Show running system information Important Points to Remember • You may stack up to eight S55s systems. • You may not stack a combination of S-Series models. S55 systems can only stack with other S55 systems. • All stack units must have the same version of FTOS. • Insert S55 stacking modules in the lower optional module slot (slot 0) only. The upper optional module slot does not support stacking modules. S-Series Stacking Installation Tasks • Create an S-Series Stack • Add a Unit to an S-Series Stack • Remove a Unit from an S-Series Stack • Merge Two S-Series Stacks • Split an S-Series Stack Create an S-Series Stack Stacking modules are pluggable units in the back of the unit that switch traffic between units in a stack. Units are connected using bi-directional stacking cables; if you stacking modules have two ports, it does not matter if you connect port A to B, or A to A, or B to B. Install stacking modules before powering the unit. If you install a stacking module while the unit is online, FTOS does not register the new hardware; in this case, you must reload the unit. 722 | Stacking S-Series Switches