Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 64

www.dell.com | support.dell.com Figure 4-8. Telnet to Another Network Device Force10# telnet 10.11.80.203 Trying 10.11.80.203... Connected to 10.11.80.203. Exit character is '^]'. Login: Login: admin Password: Force10>exit Force10#telnet 2200:2200:2200:2200:2200::2201 Trying 2200:2200:2200:2200:2200::2201... Connected to 2200:2200:2200:2200:2200::2201. Exit character is '^]'. FreeBSD/i386 (freebsd2.force10networks.com) (ttyp1) login: admin Force10# Lock CONFIGURATION mode FTOS allows multiple users to make configurations at the same time. You can lock CONFIGURATION mode so that only one user can be in CONFIGURATION mode at any time (Message 2). A two types of locks can be set: auto and manual. • Set an auto-lock using the command configuration mode exclusive auto from CONFIGURATION mode. When you set an auto-lock, every time a user is in CONFIGURATION mode all other users are denied access. This means that you can exit to EXEC Privilege mode, and re-enter CONFIGURATION mode without having to set the lock again. • Set a manual lock using the command configure terminal lock from CONFIGURATION mode. When you configure a manual lock, which is the default, you must enter this command time you want to enter CONFIGURATION mode and deny access to others. Figure 4-9. Locking CONFIGURATION mode Force10(conf)#configuration mode exclusive auto Force10(conf)#exit 3d23h35m: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by console Force10#config ! Locks configuration mode exclusively. Force10(conf)# If another user attempts to enter CONFIGURATION mode while a lock is in place, Message 1 appears on their terminal. Message 1 CONFIGURATION mode Locked Error % Error: User "" on line console0 is in exclusive configuration mode 64 | Management