Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 691

To obtain a value for any of the MIB Objects in Table 8: Step 1 Task Get a copy-config MIB object value. snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address [OID.index | mib-object.index • index is the index value used in the snmpset command used to complete the copy operation. Note: You can use the entire OID rather than the object name. Use the form: OID.index, as shown in Figure 62. Figure 61 and Figure 62 are examples of using the command snmpget to obtain a MIB object value. These examples assume that: • the server OS is Unix • you are using SNMP version 2c • the community name is public, and • the file f10-copy-config.mib is in the current directory. Note: In Unix, enter the command snmpset for help using this command. Figure 61 shows the command syntax using MIB object names, and Figure 62 shows the same command using the object OIDs. In both cases, the object is followed by same index number used in the snmpset command. Figure 38-13. Obtaining MIB Object Values for a Copy Operation using Object-name Syntax > snmpget -v 2c -c private -m ./f10-copy-config.mib 10.11.131.140 copyTimeCompleted.110 FORCE10-COPY-CONFIG-MIB::copyTimeCompleted.110 = Timeticks: (1179831) 3:16:38.31 Figure 38-14. Obtaining MIB Object Values for a Copy Operation using OID Syntax > snmpget -v 2c -c private 10.11.131.140 .1.3.6.1.4.1.6027.3.5.1.1.1.1.13.110 SNMPv2-SMI::enterprises.6027.3.5.1.1.1.1.13.110 = Timeticks: (1179831) 3:16:38.31 Manage VLANs using SNMP The qBridgeMIB managed objects in the Q-BRIDGE-MIB, defined in RFC 2674, enable you to use SNMP manage VLANs. Create a VLAN Use the dot1qVlanStaticRowStatus object to create a VLAN. The snmpset operation in Figure 38-15 creates VLAN 10 by specifying a value of 4 for instance 10 of the dot1qVlanStaticRowStatus object. Simple Network Management Protocol | 691