Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 448
Preventing a Host from Joining a Group, Multicast Features
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 448 highlights
Figure 23-2. Preventing a Host from Joining a Group 448 | Multicast Features www.dell.com | support.dell.com Source 2 10.11.1.2 interface GigabitEthernet 2/31 ip pim sparse-mode ip address 10.11.23.1/24 no shutdown interface GigabitEthernet 3/21 ip pim sparse-mode ip address 10.11.23.2/24 no shutdown Source 1 10.11.5.2 interface GigabitEthernet 2/1 ip pim sparse-mode ip address 10.11.1.1/24 no shutdown interface GigabitEthernet 3/1 ip pim sparse-mode ip address 10.11.5.1/24 no shutdown 2/1 interface GigabitEthernet 2/11 ip pim sparse-mode ip address 10.11.12.2/24 no shutdown R1(conf-if-vl-400)# do show ip pim tib RP interface GigabitEthernet 1/21 ip pim sparse-mode ip address 10.11.12.1/24 no shutdown PIM Multicast Routing Table R1 Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned, R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT, M - MSDP created entry, A - Candidate for MSDP Advertisement K - Ack-Pending State Timers: Uptime/Expires Interface state: Interface, next-Hop, State/Mode R2 3/1 2/31 3/21 239.0.0.2 239.0.0.1 R3 2/11 ip multicast-routing 3/11 ip pim rp-address 10.11.12.2 group-address 224.0.0.0/4 router rip network 10.0.0.0 interface GigabitEthernet 3/11 ip pim sparse-mode ip address 10.11.13.2/24 no shutdown 1/21 1/31 interface GigabitEthernet 1/31 ip pim sparse-mode ip address 10.11.13.1/24 no shutdown R1(conf )#do show run acl ! ip access-list extended igmpjoinfilR2G2 seq 5 permit ip any host 239.0.0.1 R1(conf-if-vl-300)# do show ip pim tib (*, 239.0.0.1), uptime 00:00:06, expires 00:00:00, RP 10.11.12.2, flags: SCJ Incoming interface: GigabitEthernet 1/21, RPF neighbor 10.11.12.2 Outgoing interface list: Vlan 400 Forward/Sparse 00:00:06/Never interface Vlan 400 ip pim sparse-mode ip address 10.11.4.1/24 untagged GigabitEthernet 1/2 ip igmp access-group igmpjoinfilR2G2 no shutdown ip igmp snooping enable interface Vlan 300 ip pim sparse-mode ip address 10.11.3.1/24 untagged GigabitEthernet 1/1 no shutdown Receiver 1 10.11.3.2 Group: 239.0.0.1, 239.0.0.2 Receiver 2 10.11.4.2 Group: 239.0.0.1, 239.0.0.2 PIM Multicast Routing Table Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned, R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT, M - MSDP created entry, A - Candidate for MSDP Advertisement K - Ack-Pending State Timers: Uptime/Expires Interface state: Interface, next-Hop, State/Mode (*, 239.0.0.1), uptime 00:00:07, expires 00:00:00, RP 10.11.12.2, flags: SCJ Incoming interface: GigabitEthernet 1/21, RPF neighbor 10.11.12.2 Outgoing interface list: Vlan 300 Forward/Sparse 00:00:07/Never (*, 239.0.0.2), uptime 00:01:10, expires 00:00:00, RP 10.11.12.2, flags: SCJ Incoming interface: GigabitEthernet 1/21, RPF neighbor 10.11.12.2 Outgoing interface list: Vlan 300 Forward/Sparse 00:01:10/Never