Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 495

Use the following command in EXEC Privilege mode to configure the debugging options of an OSPFv3 process: Command Syntax Command Mode Usage debug ipv6 ospf packet {type EXEC Privilege slot/port} View debug messages for all OSPFv3 interfaces. • packet: view OSPF packet information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information (e.g. passive-interface gi 2/1). • For a port channel, enter the keyword port-channel followed by a number from 1 to 255 for TeraScale and ExaScale (e.g. passive-interface po 100) • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information ( e.g. passive-interface ten 2/3). • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094 (e.g. passive-interface vlan 2222). E-Series ExaScale platforms support 4094 VLANs with FTOS version 8.2.1.0 and later. Earlier ExaScale supports 2094 VLANS. Sample Configurations for OSPFv2 The following configurations are examples for enabling OSPFv2. These are not comprehensive directions. They are intended to give you a some guidance with typical configurations. You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to support your own IP Addresses, Interfaces, Names, etc. Basic OSPFv2 Router Topology The following illustration is a sample basic OSPFv2 topology. Open Shortest Path First (OSPFv2 and OSPFv3) | 495