Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 594

www.dell.com | support.dell.com Debug RIP The debug ip rip command enables RIP debugging. When debugging is enabled, you can view information on RIP protocol changes or RIP routes. To enable RIP debugging, use the following command in the EXEC privilege mode: Command Syntax debug ip rip [interface | database | events | trigger] Command Mode EXEC privilege Purpose Enable debugging of RIP. Figure 32-6 shows the confirmation when the debug function is enabled. Figure 32-6. debug ip rip Command Example Force10#debug ip rip RIP protocol debug is ON Force10# To disable RIP, use the no debug ip rip command. RIP Configuration Example The example in this section shows the command sequence to configure RIPv2 on the two routers shown in Figure 32-7 - "Core 2" and "Core 3". The host prompts used in the example screenshots reflect those names. The screenshots are divided into the following groups of command sequences: • Configuring RIPv2 on Core 2 on page 595 • Core 2 Output on page 595 • RIP Configuration on Core 3 on page 597 • Core 3 RIP Output on page 597 • RIP Configuration Summary on page 599 Figure 32-7. RIP Topology Example GigE 2/41 10.200.10.0 /24 GigE 2/42 10.300.10.0 /24 GigE 3/43 192.168.1.0 /24 GigE 3/44 192.168.2.0 /24 Core 2 GigE 2/31 GigE 2/11 10.11.10.1 /24 GigE 2/31 10.11.20.2 /24 GigE Core 3 3/21 GigE 3/11 10.11.30.1 /24 GigE 3/21 10.11.20.1 /24 594 | Routing Information Protocol