Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 226

www.dell.com | support.dell.com • If a the standby RPM has a profile different from the primary RPM, the card reboots so that it can load the proper profile. To change the CAM profile on the entire system: Step 1 Task Command Syntax Command Mode Select a CAM profile. cam-profile profile microcode microcode CONFIGURATION Note: If selecting a cam-profile for VRF (cam-profile ipv4-vrf or ipv4-v6-vrf), implement the command in the CONFIGURATION mode only. If you use EXEC Privilege mode, the linecards may go into an error state. 2 Save the running-configuration. 3 Verify that the new CAM profile will be written to the CAM on the next boot. 4 Reload the system. copy running-config startup-config show cam-profile summary reload EXEC Privilege EXEC Privilege EXEC Privilege CAM Allocation c s User Configurable CAM Allocations is available on platforms: Allocate space for IPV4 ACLs and QoS regions, and IPv6 6 ACLs and QoS regions on the C-Series and S-Series by using the cam-acl command in CONFIGURATION mode. The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. Note that there are 16 FP blocks, but the System Flow requires 3 blocks that cannot be reallocated. The default CAM Allocation settings on a C-Series system are: • L3 ACL (ipv4acl): 6 • L2 ACL(l2acl) : 5 • IPv6 L3 ACL (ipv6acl): 0 • L3 QoS (ipv4qos): 1 • L2 QoS (l2qos): 1 • L2PT (l2pt): 1 • MAC ACLs (ipmacacl): 2 • ECFMACL (ecfmacl): 0 • VMAN QoS (vman-qos): 0 • VMAN Dual QoS (vman-dual-qos): 0 The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use either even or odd numbered ranges. 226 | Content Addressable Memory