Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 782

www.dell.com | support.dell.com Figure 45-15. Command Example: track Force10(conf-if-gi-1/1)#vrrp-group 111 Force10(conf-if-gi-1/1-vrid-111)#track gigabitethernet 1/2 Force10(conf-if-gi-1/1-vrid-111)# Figure 45-16. Command Example Display: track in VRID mode Force10(conf-if-gi-1/1-vrid-111)#show conf ! vrrp-group 111 advertise-interval 10 authentication-type simple 7 387a7f2df5969da4 no preempt priority 255 track GigabitEthernet 1/2 virtual-address 10.10.10.1 virtual-address 10.10.10.2 virtual-address 10.10.10.3 virtual-address 10.10.10.10 Force10(conf-if-gi-1/1-vrid-111)# Sample Configurations The following configurations are examples for enabling VRRP. These are not comprehensive directions. They are intended to give you a some guidance with typical configurations. You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to support your own IP Addresses, Interfaces, Names, etc. Figure 45-17 is a sample configuration for enabling VRRP. Figure 45-18 illustrates the topology created with that CLI configuration. 782 | Virtual Router Redundancy Protocol (VRRP)