Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 63

To change the timeout period or disable EXEC timeout. Task Command Syntax Set the number of minutes and seconds. exec-timeout minutes [seconds] Default: 10 minutes on console, 30 minutes on VTY. Disable EXEC timeout by setting the timeout period to 0. Return to the default timeout values. no exec-timeout View the configuration using the command show config from LINE mode. Figure 4-7. Configuring EXEC Timeout Force10(conf)#line con 0 Force10(config-line-console)#exec-timeout 0 Force10(config-line-console)#show config line console 0 exec-timeout 0 0 Force10(config-line-console)# Command Mode LINE LINE Telnet to Another Network Device To telnet to another device: Task Command Syntax Telnet to the peer RPM. You do not need to configure the management port on the peer RPM to be able to telnet to it. telnet-peer-rpm Telnet to a device with an IPv4 or IPv6 address. If you do not enter an IP address, FTOS enters a Telnet dialog that prompts you for one. • Enter an IPv4 address in dotted decimal format (A.B.C.D). • Enter an IPv6 address in the format 0000:0000:0000:0000:0000:0000:0000:0000. Elision of zeros is supported. telnet [ip-address] Command Mode EXEC Privilege EXEC Privilege Management | 63