Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 592

www.dell.com | support.dell.com Figure 32-5. show ip protocols Command Example Force10#show ip protocols Routing Protocols is RIP Sending updates every 30 seconds, next due in 11 Invalid after 180 seconds, hold down 180, flushed after 240 Output delay 8 milliseconds between packets Automatic network summarization is in effect Outgoing filter for all interfaces is Incoming filter for all interfaces is Default redistribution metric is 1 Default version control: receive version 2, send version 2 RIPv2 configured Interface Recv Send globally FastEthernet 0/0 2 1 2 Different RIP versions Routing for Networks: configured for this 10.0.0.0 interface Routing Information Sources: Gateway Distance Last Update Distance: (default is 120) Force10# Generate a default route Traffic is forwarded to the default route when the traffic's network is not explicitly listed in the routing table. Default routes are not enabled in RIP unless specified. Use the default-information originate command in the ROUTER RIP mode to generate a default route into RIP. In FTOS, default routes received in RIP updates from other routes are advertised if the default-information originate command is configured. To configure FTOS to generate a default route, use the following command in the ROUTER RIP mode: Command Syntax default-information originate [always] [metric value] [route-map route-map-name] Command Mode ROUTER RIP Purpose Specify the generation of a default route in RIP. Configure the following parameters: • always: enter this keyword to always generate a default route. • value range: 1 to 16. • route-map-name: name of a configured route map. Use the show config command in the ROUTER RIP mode to confirm that the default route configuration is completed. 592 | Routing Information Protocol