Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 227

You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. To configure the IPv4 and IPv6 ACLs and Qos regions on the entire system: Step 1 Task Command Syntax Command Mode Select a cam-acl action cam-acl [default | l2acl] CONFIGURATION Note: Selecting default resets the CAM entries to the default settings. Select l2acl to allocate space for the ACLs, and QoS regions. 2 Enter the number of FP blocks for each region. l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number, l2pt number ipmacacl number ecfmacl number [vman-qos | vman-dual-qos number EXEC Privilege 3 Verify that the new settings will be written show cam-acl to the CAM on the next boot. EXEC Privilege 4 Reload the system. reload EXEC Privilege Test CAM Usage c e s The test cam-usage command is supported on platforms This command applies to both IPv4 and IPv6 CAM profiles, but is best used when verifying QoS optimization for IPv6 ACLs. Use this command to determine whether sufficient ACL CAM space is available to enable a service-policy. Create a Class Map with all required ACL rules, then execute the test cam-usage command in Privilege mode to verify the actual CAM space required. Figure 10-3 gives a sample of the output shown when executing the command. The status column indicates whether or not the policy can be enabled. Figure 10-3. Command Example: test cam-usage (C-Series) Force10#test cam-usage service-policy input TestPolicy linecard all Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 2 | 1 | IPv4Flow | 232 | 0 | Allowed 2 | 1 | IPv6Flow | 0 | 0 | Allowed 4 | 0 | IPv4Flow | 232 | 0 | Allowed 4 | 0 | IPv6Flow | 0 | 0 | Allowed Force10# Content Addressable Memory | 227