Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 471

Use the no router ospf process-id command syntax in the CONFIGURATION mode to disable OSPF. Use the clear ip ospf process-id command syntax in EXEC Privilege mode to reset the OSPFv2 process. Use the show ip ospf process-id command in EXEC mode (Figure 408) to view the current OSPFv2 status. Figure 24-8. Command Example: show ip ospf process-id Force10#show ip ospf 55555 Routing Process ospf 55555 with ID 10.10.10.10 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 Force10# Enable Multi-Process OSPF Multi-Process OSPF allows multiple OSPFv2 processes on a single router. The following list shows the number of processes supported on each platform type. • The E-Series supports up to 30 OSPFv2 processes. • The C-Series supports up to 6 OSPFv2 processes. • The S50 and S25 support up to 4 OSPFv2 processes. • The S55, S60, and S4810 support up to 16 OSPFv2 processes. • The Z9000 supports up to 3 OSPFv2 processes. Follow the same steps as above, when configuring a single OSPF process. Repeat them as often as necessary for the desired number of processes. Once the process is created, all other configurations apply as usual, Step Command Syntax 1 ip address ip-address mask 2 no shutdown Command Mode Usage CONFIG-INTERFACE Assign an IP address to an interface. Format: A.B.C.D/M If using a Loopback interface, refer to Loopback Interfaces on page 293. CONFIG-INTERFACE Enable the interface. Open Shortest Path First (OSPFv2 and OSPFv3) | 471