Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 307

The show range command is available under interface range mode. This command allows you to display all interfaces that have been validated under the interface range context. The show configuration command is also available under the interface range mode. This command allows you to display the running configuration only for interfaces that are part of interface range. Bulk Configuration Examples The following are examples of using the interface range command for bulk configuration: • Create a single-range • Create a multiple-range • Exclude duplicate entries • Exclude a smaller port range • Overlap port ranges • Commas • Add ranges Create a single-range Figure 15-17. Creating a Single-Range Bulk Configuration Force10(config)# interface range gigabitethernet 5/1 - 23 Force10(config-if-range-gi-5/1-23)# no shutdown Create a multiple-range Figure 15-18. Creating a Multiple-Range Prompt Force10(conf)#interface range tengigabitethernet 3/0 , gigabitethernet 2/1 - 47 , vlan 1000 Force10(conf-if-range-gi-2/1-47,so-5/0)# Exclude duplicate entries Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt: Figure 15-19. Interface Range Prompt Excluding Duplicate Entries Force10(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3 Force10(conf-if-range-vl-1,vl-3)# Force10(conf)#interface range gigabitethernet 2/0 - 23 , gigabitethernet 2/0 - 23 , gigab 2/0 - 23 Force10(conf-if-range-gi-2/0-23)# Interfaces | 307