Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 66

www.dell.com | support.dell.com Step 4 5 6 7 8 9 10 11 Task Command Syntax Set the system parameters to ignore the startup configuration file when the system reloads. setenv stconfigignore true To save the changes, use the saveenv saveenv command Reload the system. Copy startup-config.bak to the running config. reset copy flash://startup-config.bak running-config Remove all authentication statements no authentication login you might have for the console. no password Save the running-config. copy running-config startup-config Set the system parameters to use the startup configuration file when the system reloads. setenv stconfigignore false Save the running-config. copy running-config startup-config Command Mode uBoot uBoot uBoot EXEC Privilege LINE EXEC Privilege uBoot EXEC Privilege Recovering from a Forgotten Enable Password on the S55 If you forget the enable password: Step 1 2 3 4 5 6 7 Task Command Syntax Command Mode Log onto the system via console. Power-cycle the chassis by switching off all of the power modules and then switching them back on. Press any key to abort the boot process. You enter uBoot immediately, as indicated by the => prompt. press any key Set the system parameters to ignore the enable password when the system reloads. setenv enablepwdignore true Reload the system. reset Configure a new enable password. enable {secret | password} Save the running-config to the startup-config. copy running-config startup-config (during bootup) uBoot uBoot CONFIGURATION EXEC Privilege 66 | Management