Dell Inspiron One 2205 Service Manual - Page 48
Replacing the Processor
View all Dell Inspiron One 2205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
11. Lift the processor to remove it from the processor socket; place it aside in a safe and secure place. Replacing the Processor 1. Follow the instructions in Before You Begin. 2. Lift the release lever to the release position so that the processor socket is ready for the new processor. CAUTION: Ground yourself by touching an unpainted metal surface. 3. Unpack the new processor. 1 processor socket 3 processor 2 processor pin-1 indicator 4 release lever 4. Ensure that the release lever on the processor socket is fully extended. CAUTION: Socket pins are delicate. To avoid damage, ensure that the processor is aligned properly with the processor socket, and do not use excessive force when you install the processor. Be careful not to touch or bend the pins on the system board. CAUTION: You must position the processor correctly in the processor socket to avoid permanent damage to the processor. 5. Align the pin-1 corners of the processor and processor socket. 6. Place the processor lightly in the processor socket and ensure that the processor is positioned correctly. 7. Pivot the processor socket release lever back towards the processor socket, and snap it into place to secure the processor. 8. Clean the thermal grease from the bottom of the heat sink. CAUTION: Ensure that you apply new thermal grease. New thermal grease is critical for ensuring adequate thermal bonding, which is a requirement for optimal processor operation. 9. Apply the new thermal grease to the top of the processor. CAUTION: Ensure that the processor heat-sink is correctly seated and secure. 10. Replace the processor heat-sink (see Replacing the Processor Heat-Sink). 11. Replace the processor heat-sink fan (see Replacing the Processor Heat-Sink Fan). 12. Replace the MXM assembly (see Replacing the MXM Assembly). 13. Replace the MXM-assembly fan (see Replacing the MXM-Assembly Fan). 14. Replace the system-board shield (see Replacing the System-Board Shield).