Haier 3U19FS1ERA Service Manual - Page 135

>_]]VbTZR\ _^UZdZ_^Vb Timing setting OFF timing: when a set time has elapsed, the unit stops running. ON timing: when a set time has elapsed, the unit starts. Press "ON/OFF"switch firstly, and set up operation mode. Please regulate the clock in MODE FAN SWING advance before using the timing function. MODE COOL FAN HIGH OPERATION HEALTH TEMP 1.Press "TIME" switch. CLOCK TIME The display changes with the following sequence: ON OFF on OFF on OFF CYCLE no display C ROOM TEMP. TIMER SET RECOVERY 2.Set up "TIMER" TIMER When timing ON or timing OFF flickers, press " " or " " to ON CHECK FILTER regulate the time RESET Press" "or " "set up ON/OFF time. The setting time increases ten minutes each time you press " " ON/OFF switch. The setting time decreases ten minutes each time you press " " switch. When setting timing ON and timing OFF at the same time, 13 2 press "timing" switch to change the setting item. 3.Time setting is achieved. Press"setting"switch. Cancel timing If you want to change the timing mode to normal operation, press "timing" until there is no timing display. When the timing is invalid, the mode is in normal operation. parts of wired controller explanation : 1.The unit starts or stops at the setting time. Meanwhile, it displays the timing time. 2."ON Timing, OFF timing and circulation"means that the unit is on and off at the setting time everyday. Notes The shorter setting time will be carried out firstly. If the ON timing and OFF timing are the same, the setting is invalid. Even in timing condition, you may start or close the unit through pressing "ON/OFF" switch.