Haier 3U19FS1ERA Service Manual - Page 82

According to SW5-2, the setting is as fo

Get Haier 3U19FS1ERA PDF manuals and user guides View all Haier 3U19FS1ERA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 82 highlights

>_]]VbTZR\ _^UZdZ_^Vb not go down greatly. Ambient temp. TA≤27degree, when compressor stops, the electric heater will be electrified. When TA≥32degree, or compressor running, the electric heater will be off. Heater ON OFF Ambient temp. TA(℃) 27 32 3.6 Control of defrosting in heating In heating mode, defrosting temp. sensor will check the frosting condition of outdoor heat exchanger and make defrosting control. 3.6.1 Enter condition: ①In heating mode, if the compressor has run for 10 minutes continously and run for 45 minutes in all, the system will measure the defrosting temperature sensor Te and outdoor ambient temp. sensor TA, if the below condition can be met for continous 5 minutes, the unit will enter defrosting operation: Te≤C×TA－α Herein: C：TA＜0℃，C=0.8 TA≥0℃，C=0.6 According to SW5-2, the setting is as follow: in the place easy to frost, it is H; when out of factory, it is M. Jumper M(out of factory) H selection α(℃) 8(E) 6(E) ②Defrosting entering condition: -15℃≤C×TA－α≤-2℃ ③Stop and Pause condition of compressor running accumulative time in heating mode: Checking Stop: running operation changes from heating to cooling. Checking Pause: thermostat OFF, or the unit stops. 3.6.2 Cancel condition: It will take the max. 10 minutes from beginning defrosting to quit it. Te sensor will measure the condition of outdoor heat exchanger, if the temp. is over 7℃ for 60 seconds in all or is up to 12℃ for 30 seconds in all, the defrosting will be over. 3.6.3 Compulsory defrosting control Enter condition: in heating mode, after receiving the compulsory defrosting signal from indoor unit, the unit will perform the compulsory defrosting operation. Cancel condition: Te≥12℃ and keep for 1 minute or the defrosting time is over 10 minutes. The manual defrosting signal of indoor unit will remain until the outdoor enters defrosting mode. Note: When outdoor compressor not running, the unti still can enter manual defrosting, but it will comply with the 3-minute protection of compressor.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
not go down greatly.
±
Ambient temp. TA
≤
27degree, when compressor stops, the electric heater will be electrified.
±
When TA
≥
32degree, or compressor running, the electric heater will be off.
Heater ON
OFF
Ambient temp. TA(
℃
)
27
32
In heating mode, defrosting temp. sensor will check the frosting condition of outdoor heat exchanger and
make defrosting control.
①
In heating mode, if the compressor has run for 10 minutes continously and run for 45 minutes in all, the
system will measure the defrosting temperature sensor Te and outdoor ambient temp. sensor TA, if the
below condition can be met for continous 5 minutes, the unit will enter defrosting operation:
Te
≤
C
×
TA
－α
Herein: C
：
TA
＜
0
℃，
C=0.8
TA
≥
0
℃，
C=0.6
llow: in the place easy to frost, it is H; when out of factory, it is M.
Jumper
selection
M(out of factory)
H
α
(
℃
)
8(E)
6(E)
②
Defrosting entering condition: -15
℃≤
C
×
TA
－α≤
-2
℃
③
Stop and Pause condition of compressor running accumulative time in heating mode:
Checking Stop: running operation changes from heating to cooling.
Checking Pause: thermostat OFF, or the unit stops.
It will take the max. 10 minutes from beginning defrosting to quit it. Te sensor will measure the condition of
outdoor heat exchanger, if the temp. is over 7
℃
for 60 seconds in all or is up to 12
℃
for 30 seconds in all,
the defrosting will be over.
Enter condition: in heating mode, after receiving the compulsory defrosting signal from indoor unit, the unit
will perform the compulsory defrosting operation.
Cancel condition: Te
≥
12
℃
and keep for 1 minute or the defrosting time is over 10 minutes.
The manual defrosting signal of indoor unit will remain until the outdoor enters defrosting mode.
Note: When outdoor compressor not running, the unti still can enter manual defrosting, but it will comply
with the 3-minute protection of compressor.
±²³³´µ¶·¸¹ º·µ ±²»¼·½·²»´µ
3.6 Control of defrosting in heating
3.6.1 Enter condition:
3.6.2 Cancel condition:
3.6.3 Compulsory defrosting control
According to SW5-2, the setting is as fo