HP 1050c HP DesignJet 1000 Series Take-Up Reel UserÂ’s Guide - C60 - Page 4
Upgrading your Printer, Checking the Firmware Revision Number
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Upgrading your Printer Utilities Statistics Code rev Before installing your take-up reel, you should check that the firmware module installed in your printer supports a take-up reel. Checking the Firmware Revision Number You can find out your firmware revision number from the printer's front panel by selecting the Printer Setup menu and then "Utilities", "Statistics", and "Code rev". s If your firmware revision number is A.01.05 or higher, your take-up reel is supported and you can proceed with installation. s If your firmware revision number is A.01.04 or A.01.04A, you need to contact an HP Customer Care Centre, which will send you a free Firmware Upgrade Kit. The telephone numbers of HP Customer Care Centres in each country are listed in the Customer Care booklet provided with your take-up reel. HP DesignJet 1000 Series Take-Up Reel 4