HP BL10e HP ProLiant BL e-Class System Setup and Installation Guide - Page 49
Installing the Enclosure into the Rack
UPC - 808736933599
View all HP BL10e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Installing and Cabling the System Installing the Enclosure into the Rack WARNING: Remove the two hot-plug power supplies before installing the enclosure into the rack to reduce weight. WARNING: At least two people must lift the enclosure into the rack together. If the enclosure is loaded into the rack above chest level, a third person MUST assist with aligning the enclosure with the rails while the other two people support the weight of the enclosure. CAUTION: Do not remove the enclosure from the rack by the thumbscrews. Use the handles located above the thumbscrews. To load the enclosure into the rack: 1. Install the interconnect tray. See the "Installing the Interconnect Tray" section in this chapter. 2. Stand at the front of the rack. 3. Align the bottom of the enclosure with the top of the rack rails. HP ProLiant BL e-Class System Setup and Installation Guide 3-11