HP BL10e HP ProLiant BL e-Class System Setup and Installation Guide - Page 57
For the RJ-45 patch panel, be sure that cables are connected for each server
UPC - 808736933599
View all HP BL10e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Installing and Cabling the System 2. Connect the server blade network connectors to the network: - For the interconnect switch, be sure that at least one of the uplink connectors is cabled. Any server blade NIC can be routed to any uplink connector. However, because NIC 1 is PXE-enabled by default on each server blade, it is recommended that either port 25 or 26 of switch A be used for PXE functions. - For the RJ-21 patch panel, be sure that cables for both NIC 1 and NIC 2 are connected for each group of ten server blades you intend to install in the enclosure. The two NIC 1 RJ-21 connectors provide PXE connectivity by default to each group of ten server blades. - For the RJ-45 patch panel, be sure that cables are connected for each server blade you intend to install in the enclosure. The NIC 1 RJ-45 connector for each server blade provides PXE-enabled connectivity by default. 3. Connect an AC power cord to each hot-plug power supply. Note that the enclosure will power up as soon as an AC power cord is connected to a power source and a power supply. HP ProLiant BL e-Class System Setup and Installation Guide 3-19