HP Designjet 4500 HP Designjet 4500 Printer Series - Setup Poster - Page 9
Rear of the, printer
View all HP Designjet 4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
52 53 54 55 Open the box containing the roll module, then remove the two foam supports. 56 Remove the roll module from the packaging box. 57 Remove the roll module from the plastic bag. 58 Remove the remaining two yellow plugs from the left and right legs. It is important to remember the positions of these holes. H 59 Turn the roll module over into an inverted position as shown above. Then carry it to the front of the inverted printer. Rear of the printer Rest the roll module next to the first printer crossbar. Before the roll module is moved into its final position, please note that the roll module should sit on the pins that were located on the stand legs earlier. Three people are needed, two at the front and one at the rear of the printer. The two at the front should lift the roll module and then, with the help of the third person at the rear, lower it vertically onto the pins located earlier on the stand."