HP Model 715/100 hp 9000 series 700 model 715 workstations service handbook (a - Page 102
Power Supply
View all HP Model 715/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Power Supply Before removing the power supply, perform the following steps: S Remove the optional external graphics processor (if installed). S Remove the floor stand. S Open the system unit. Remove the two screws that secure the power supply to the chassis. Disconnect the processor board cable and any disk drive cables. Slide the power supply toward the disk drives about 1/4-inch, then lift the power supply out of the chassis. Processor Board Connector (P6) Figure 5-15. Removing the Power Supply Field Replaceable Units 5-17
Field Replaceable Units
5–17
Power Supply
Before removing the power supply, perform the following steps:
S
Remove the optional external graphics processor (if installed).
S
Remove the floor stand.
S
Open the system unit.
Remove the two screws that secure the power supply to the chassis.
Disconnect the processor board cable and any disk drive cables.
Slide the power supply toward the disk drives about 1/4–inch, then lift the power sup-
ply out of the chassis.
Processor Board
Connector (P6)
Figure 5–15.
Removing the Power Supply